Farmhouse sink mat – To install a new bathroom sink mat, you basically assemble the parts provided in the valve box through the hole that is already in the sink. Then, buy a crane with a center that matches the holes in the sink. Many kitchen sinks have two tap holes measuring 4 inches from the center of a hole in the middle of the second. And the pin molded in one piece device that sits on top of your kitchen sink. Buy a crane with 4-inch centers for this installation.
Then, turn off the hot and cold water supply lines to the sink. Open hot and cold faucet valves to drain the water from the tap in the farmhouse sink mat. And to ensure that the water supply is turned off. From under the sink, use a basin wrench to loosen the supply line nuts from the bottom of the existing tap. Take the tap. If necessary, use penetrating oil on the rusty parts to facilitate removal. Prepare sink area for the new crane by cleaning the area around the faucet holes in the sink, remove calcium deposits and old plumbers putty or caulk.
And then, set new faucet into place with the help of the gasket on one provided. If there is no packing, apply plumbers putty to the bottom of the tap to make a seal. Then, make sure the valve is correctly position on top of the farmhouse sink mat. Tighten new nuts under the sink with a basin wrench until the faucet is safe.